Technological study on high power CO2 laser cutting of small hole on middle-thick steel plates
-
1.
School of Optoelectronics Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
-
Corresponding author:
TANG Xia-hui, txh1116@mail.hus.tedu.cn
;
-
Received Date:
2007-06-11
Accepted Date:
2007-11-23
-
Abstract
Aiming at the cutting quality problems of high power CO2 laser cutting of small hole on middle-thick steel plates,the cutting technology of small hole on middle-thick steel plates was studied by using Rofin DC025 slab CO2 laser cutting system.At the same time,the effects of laser power,cutting speed and oxygen pressure on cutting quality were also studied.The key effect of temperature on cutting quality was analyzed.The results show that the best cutting quality can be obtained at the conditions of laser power 950W,cutting speed 1.0m/min,the oxygen pressure 1.0×105Pa.The cutting quality problems of high power CO2 laser cutting of small hole on middle-thick steel plates have been solved.
-
-
References
|
[1]
|
LIU D H.Laser cutting[J].Laser Journal,1992,13(4):207-213(in Chinese). |
|
[2]
|
LI X Y,ZENG X Y,HUANG W L.Status and prospect of precision laser machining[J].Laser Journal,2000,21(5):1-3(in Chinese). |
|
[3]
|
YANG Y M.Applications of precision machining with Nd:YAG laser[J].Lasers and Infrared,1997,27(6):333-337(in Chinese). |
|
[4]
|
LI X Y,ZENG X Y,LIU Y.Study of YAG Laser cutting process with stainless steel sheet[J].Chinese Journal of Lasers,2001,A28(12):1125-1129(in Chinese). |
|
[5]
|
LI Y Sh.Study on laser deep hole drilling[J].Laser Technology,1998,22(2):36-40(in Chinese). |
|
[6]
|
RAJARAM N,SHEIKH-AHMAD J,CERAGHI S H.CO2 laser cutquality of 4130 steel[J].International Journal of Machine Tools and Manufacture,2003,43(4):351-358. |
|
[7]
|
ZHENG Q G.Laser advanced manufacture[M].Wuhan:Huazhong University of Science and Technology Press,2002:25-27(in Chinese). |
|
[8]
|
LIANG Y R.Study of correlation between material surface temperature and laser average power and cutting speed[J].Aviation Precision Manufacturing Technology,1996,32(6):17-19(in Chinese). |
|
[9]
|
CHEN S L,STEENW M.The theoretical investigation of gas assisted laser cutting[C]//ICALEO.San Jose,USA:Laser Instithte of America,1991:221-227. |
|
[10]
|
KAEBERNICK H,JEROMIN A,MATHEW P.Adaptive control for laser cutting using striation frequency analysis[J].CIRP Annals-Manufacturing Technology,1998,47(1):137-139. |
|
[11]
|
CHENG H,NEIL W O.The effects of power rippling on CO2 laser cutting[J].Opt Laser Technol,1997,29(3):125-134. |
|
[12]
|
NEIL W O,STEEN W M.A three dimensional analysis of gas entrainment operating during the laser cutting process[J].J Phys,1995,D28(1):12-18. |
-
-
Proportional views
-
Map
DownLoad: