Discussion on direct manufacturing metallic pattern for sand mold based on laser cladding technology

Liu Jichang; Li Lijun

This paper discusses laser direct manufacturing metallic patterns for sand mould based on laser cladding technology.The fundamental principle and characteristics of this rapid manufacturing (RM) technology are introduced.According to analysis of the structure and working condition of metallic pattern for sand mould,it is demonstrated that this RM technology would make great contributions to fabrication of this pattern.In practice,to acquire lightweight products and to decrease consumption in the procedure,corresponding measures are put forward to improve the process of laser cladding.Finally,it is indicated that lightweight patterns would be produced in low-consumption procedures while the relative techniques and their integration being advanced enough.

1. Laser Institute, Hunan University, Changsha, 410082;

2. Zhuzhou Institute of Technology, Zhuzhou, 412008

Received Date: 2003-01-12

Accepted Date: 2003-02-27

Available Online: 2003-11-25

Abstract: This paper discusses laser direct manufacturing metallic patterns for sand mould based on laser cladding technology.The fundamental principle and characteristics of this rapid manufacturing (RM) technology are introduced.According to analysis of the structure and working condition of metallic pattern for sand mould,it is demonstrated that this RM technology would make great contributions to fabrication of this pattern.In practice,to acquire lightweight products and to decrease consumption in the procedure,corresponding measures are put forward to improve the process of laser cladding.Finally,it is indicated that lightweight patterns would be produced in low-consumption procedures while the relative techniques and their integration being advanced enough.

HTML

Reference (13)

[1]	颜永年,张人佶,单忠德 et al.航空制造技术,2002(4):17～21,30.
[2]	张海鸥,徐继彭.航空制造技术,2002(4):22～23,66.
[3]	黄树槐,张祥林,马黎 et al.中国机械工程,1997,8(5):8～12.
[4]	Pham D T,Dimov S S.Journal of Mechanical Engineering Science,2003,217(1):1～23.
[5]	Hu Y P,Chun C W,Mukherjee K.Journal of Materials Science,1998,33:1287～1292
[6]	焦向东,佟泽民,邓双城 et al.制造技术与机床,2000(7):8～9.
[7]	Kahlen F J,Kar A.Transactions of the ASME,2001,123:38～44.
[8]	Vasinonta A,Beuth J L,Griffith M L.Journal of Manufacturing Science and Engineering,2001,123:615～622.
[9]	Kruth J P,Leu M C,Nakagawa T.Annals of the CIRP,1998,47(2):525～540.
[10]	黄卫东,李延民,冯利萍 et al.材料工程,2002(3):40～43,27.
[11]	梅琼风,吴志超,叶升平 et al.特种铸造及有色合金,2002(1):10～11.
[12]	钟敏林,宁国庆,刘文今.激光技术,2002,26(5):388～391.
[13]	Hensinger D M,Ames A L.Proceedings of the 2000 IEEE International Conference on Robotics Automotion,2000,4:3095～3100.

Discussion on direct manufacturing metallic pattern for sand mold based on laser cladding technology

Abstract

References

Proportional views

通讯作者: 陈斌, bchen63@163.com

Proportional views