[1] KLIGERMAN Y,ETSION I,SHINKARENKO A.Improving tribological performance of piston rings by partial surface texturing[J].Journal of Tribology,2005,127 (3):632-638.
[2] RYK G,KLIGERMAN Y,ETSION I,et al.Experimental investigation of partial laser surface texturing for piston-ring friction reduction[J].Tribolngy Transactions,2005,48 (4):583-588.
[3] TOMANIK E.Friction and wear bench tests of different engine liner surface finishes[J].Tribology International,2008,41 (11):1032-1038.
[4] RYK G,KLIGERMAN Y,ETSION I,et al.Experimental investigation of laser surface texturing for reciprocating automotive components[J].Tribolngy Transactions,2002,45 (4):444-449.
[5] KOVALCHENKO A,AJAYI O,ERDEMIR A,et al.The effect of laser surface texturing on transitions in lubrication regimes during unidirectional sliding contact[J].Tribology International,2005,38(3):219-225.
[6] KRUUSING A.Underwater and water-assisted laser processing:part 2--Etching,cutting and rarely used methods[J].Optics and Lasers in Engineering,2004,41 (2):329-352.
[7] DUBEY A K,YADAVA V.Experimental study of Nd:YAG laser beam machining-an overview[J].Journal of Materials Processing Technology,2008,195 (1/3):15-26.
[8] ZHANG H,XU W,WANG J.Investigation of a novel hybrid process of laser drilling assisted with jet electrochemical machining[J].Optics and Lasers in Engineering,2009,47 (11):1242-1249.
[9] TUNNA L,KEARNS A,ONEILL W,et al.Micromaehining of copper using Nd:YAG laser radiation at 1064,532 and 355nm wavelengths[J].Optics Laser Technology,2001,33(3):135-143.
[10] LI L,CHARA C.Chemical assisted laser machining for the minimisation of recast and heat affected zone[J].CIRP Annals-Manufactur-ing Technology,2004,53(1):175-178.
[11] LIU D H.Laser drilling[J].Laser Jonmal,1992,13(3):151-155(in Chinese).